Becker R40/17C Betriebsanleitung Seite 1

R12/17C...R40/17CVersion: PROF+A2 en Assembly and Operating Instructions Roller shutter drive with integrated radio receiver915.3 Mhz Important info

Assembling the drive adapter with drive adapter safety catchPut the drive adapter (1) onto the drive shaft of the tubular drive. You can see whichway

Mounting the drive in the tubeFor profile tubes:In the case of some drive adapters, tolerances of the groove widths in different bar‐rels can be offse

First operationExplanation of symbolsUP buttonSTOP buttonDOWN buttonProgramming buttonThe tubular drive clicks once to confirmThe tubular drive clicks

Programming the master transmitter Press the programming button for 3 seconds when it is ready to programme.[ The tubular drive makes a clicking sound

Setting the limit positionsNoteThe limit positions can only be set with the master transmitter. The shutter direction must be correct. Whensetting the

Upper point to lower stopOpen to the desired upper limit position.Press the programming button and, within 3 seconds, also press the UP button andhold

NoteOnce set, the limit positions can only be deleted with the master transmitter. Deleted limit positions are dis‐played on the limit position status

Programming additional transmittersNoteIn addition to the master transmitter, up to 15 further transmitters can be programmed in the tubular drive.Pre

Overwriting the masterThere are two ways to overwrite the master:▪ Readying the tubular drive for programming by switching on the power▪ Readying the

Upper anti-freeze mechanismThe upper anti-freeze mechanism helps to prevent the roller shutter from freezing in the upper limit position, as the rolle

Table of contentsContents ...

Fly screen protection functionIf the fly screen protection function is activated, obstacle detection is activated after a revolution of the barrel of

Deleting the run times NoteWhen deleting, both run times are always deleted.To delete the UP and DOWN run time, press the STOP button for 10 seconds.

What to do if...?Problem Cause RemedyTubular drive is not functioning. No transmitter programmed. Programme new transmitter.Transmitter is out of rang

Sample wiring diagramNLPEElectronicsBlackBrownBlueGreen/yellow 23

Declaration of conformity 24

25

26

27

2010 300 570 0a 06/03/2013

ContentsGeneralThese tubular drives are high-quality products with the following features:▪ Optimised for roller shutter operation▪ Individual, group

Explanation of nomenclatureTubular drives:Example: R12/17C PROF+R 12 / 17 C PROF+Type Nm min-1C-Plug =plug-in connecting cableLimit switch versionTyp

WarrantyStructural modifications and incorrect installation which are not in accordance with these and our other instructions can result inserious inj

CautionImportant safety instructions for installation and commissioningFailure to observe these instructions can lead to serious injuries.▪ Observe th

Intended useThe type of tubular drive described in these instructions is intended solely for the operation of roller shutters.This type of tubular dri

Disassembling the plug-in connecting cable for tubular drives dia. 45 and dia. 58CautionPrior to disassembly, the power supply to the connecting cable

InstallationAssembling the driveAttentionTo connect the drive to the driven part, solely mechanical accessory components made by the drive manufac‐tur